Dangerous goods requiring approval under Special Provisions A1 or A2 of the Technical Instructions may only be carried on a passenger or cargo aircraft in Australian territory with the approval of the Civil Aviation Safety Authority (CASA). Applications for approval should be lodged with CASA at least ten days prior to the proposed flight.
,
Staatliche Abweichung: CA 9
Dangerous goods requiring approval under Special Provisions A1, A2 or A201 of the Technical Instructions may only be transported to, from or within Canada with the approval of the Canadian authority for the air transport of dangerous goods.
The Canadian authority for the transport of dangerous goods for CA 9:
Manager, Approvals and Special Regulatory Projects
Transport Canada
Transport Dangerous Goods Directorate
330 Laurier Street West
Ottawa, Ontario
Canada K1A 0N5
Facsimile: (613) 993-8639
Email: tdgapprovals-approbationstmd@tc.gc.ca
,
Staatliche Abweichung: IR 3
Dangerous goods which are principally forbidden for air transport and are subjected to Special Provision A1 or A2 of the Technical Instructions may be imported into the Islamic Republic of Iran subject to prior permission from the Civil Aviation Organization of Iran.
Application for permission must be made at least fifteen days prior to the proposed flight date and must be addressed to:
Vice President C.A.O.I.R. of Iran
Deputy of Flight Standard
Civil Aviation Organization
Mehrabad International Airport
Tehran, Islamic Republic of Iran
Facsimile: +98 21 66 03 65 52
,
Staatliche Abweichung: NL 1
Dangerous goods requiring approval under Special Provision A1 or A2 of these Instructions, may not be transported on a passenger aircraft or cargo aircraft (as appropriate) to, from or through the Netherlands without prior approval of the Ministry of Transport, Public Works and Water Management, irrespective of whether or not the Netherlands is the State of Origin.
Application for all approvals should be made at least 10 days prior to the proposed flight date and must be submitted to:
Human Environment and Transport Inspectorate (CAA - NL)
Ministry of Infrastructure and the Environment
Certification and Approvals Department
Postbus 575
2130 AN Hoofddorp
The Netherlands
For substances where this variation is identified in column 6 of Table 3-1, the following provisions apply:
if A1 appears in column 7, the substance may not be transported to, from or within the United States aboard a passenger aircraft without the prior approval of the appropriate authority of the U.S. (see US 1);
if A2 appears in column 7, the substance may not be transported to, from or within the United States aboard a passenger or cargo aircraft without the prior approval of the appropriate authority of the U.S. (see US 1);
prototype lithium batteries and cells transported in accordance with Special Provision A88, lithium cells or batteries including when packed with equipment or contained in equipment transported in accordance with Special Provision A99, and organic peroxides and self-reactive substances that are not identified by a technical name in 49 CFR 173.225(b) may not be transported to, from, or within the United States aboard a passenger or cargo aircraft without the prior approval of the appropriate authority of the U.S. (see US 1).
Staatliche Abweichung: US 4
Substances subject to additional requirements for air transport to, from or within the United States are described below. The additional requirements in III also apply to U.S. carriers operating outside the U.S.
Hazardous substances. When a substance, including its mixtures and solutions, listed in Appendix A to 49 CFR 172.101 is offered for transport in a package in which the net quantity of the substance equals or exceeds the reportable quantity (RQ) indicated for the substance in Appendix A, the substance, mixture or solution is considered a hazardous substance unless:
it is a petroleum product that is a lubricant or fuel; or
it is in a concentration less than that shown in the following table based on the RQ specified for the material:
RQ Kilograms
Concentration Per cent
by weight PPM
45.4
0.2
2 000
4.54
0.02
200
0.45
0.002
20
For mixtures of radionuclides, see Note 7 to Appendix A to 49 CFR 172.101.
Hazardous substances, except for those that are hazardous wastes as defined in Section II below, must comply with the following requirements:
For a hazardous substance that is a dangerous good according to these Technical Instructions other than under the proper shipping names "ENVIRONMENTALLY HAZARDOUS SUBSTANCE, LIQUID, N.O.S." or "ENVIRONMENTALLY HAZARDOUS SUBSTANCE, SOLID, N.O.S.":
unless already included in the required shipping name, and except for radioactive material in Class 7, the name of the hazardous substance shall be shown in parentheses, in association with the dangerous goods description on the transport document and in association with the proper shipping name on package marking. If the material contains two or more hazardous substances, at least two hazardous substances, including the two with the lowest reportable quantities (RQs), must be identified; and
the letters "RQ" shall be entered on the transport document either before or after the basic description and in association with the proper shipping name required to be marked on the package.
For hazardous substances that do not meet any other definition of dangerous goods according to these Technical Instructions:
the hazardous substance shall be shipped under the basic dangerous goods description "UN 3082, ENVIRONMENTALLY HAZARDOUS SUBSTANCE, LIQUID, N.O.S., Class 9, III" or "UN 3077, ENVIRONMENTALLY HAZARDOUS SUBSTANCE, SOLID, N.O.S., Class 9, III", as appropriate, and in accordance with the requirements of these Technical Instructions applying to the shipment of goods under this description;
except for 4;1.1.6, the package must meet all applicable General Packing Requirements of Part 4, Chapter 1 of these Instructions that would apply to dangerous goods of Packing Group III;
the letters "RQ" shall be entered on the transport document either before or after the basic description and in association with the proper shipping name required to be marked on the package; and
the name of the hazardous substance shall be shown in parentheses, in association with the dangerous goods description on the transport document and in association with the proper shipping name on package marking. If the material contains two or more hazardous substances, at least two hazardous substances, including the two with the lowest reportable quantities (RQs), must be identified.
Note.- The list of Hazardous Substances and the applicable RQ as shown in Appendix A to 49 CFR 172.101 is available via the internet at:
Hazardous waste.A hazardous waste is any material that is subject to the hazardous waste manifest requirements of the United States Environmental Protection Agency (EPA) specified in 40 CFR Part 262. The following requirements apply to the transport of hazardous wastes:
For a hazardous waste that is a dangerous good according to these Technical Instructions other than under the proper shipping names "ENVIRONMENTALLY HAZARDOUS SUBSTANCE, LIQUID, N.O.S." or "ENVIRONMENTALLY HAZARDOUS SUBSTANCE, SOLID, N.O.S.":
the word "WASTE" must precede the proper shipping name in the transport document and package markings; and
the requirements of 49 CFR 172.205, with respect to the hazardous waste manifest apply.
For hazardous wastes that do not meet any other definition of dangerous goods according to these Technical Instructions:
the hazardous wastes shall be shipped under the basic dangerous goods description "UN 3082, WASTE ENVIRONMENTALLY HAZARDOUS SUBSTANCE, LIQUID, N.O.S., Class 9, III" or "UN 3077, WASTE ENVIRONMENTALLY HAZARDOUS SUBSTANCE, SOLID, N.O.S., Class 9, III", as appropriate, and in accordance with the requirements of these Technical Instructions applying to the shipment of goods under this description;
the package must meet all applicable General Packing Requirements of Part 4, Chapter 1 that would apply to dangerous goods of Packing Group III;
the requirements of 49 CFR 172.205 with respect to the hazardous waste manifest apply; and
for those hazardous wastes that meet the definition of a hazardous substance, the letters "Q" and the name of the hazardous substance in parentheses shall be shown in association with the basic description on transport documents and package markings. association with the basic description on transport documents and package markings. If the material contains two or more hazardous substances, at least two hazardous substances, including the two with the lowest reportable quantities (RQs), must be identified.
Note 1.- Hazardous wastes can only be transported within the United States by carriers who have obtained a Waste Transporter Identification Number from the Environmental Protection Agency (EPA).
Note 2.- The assignment of substances described in I and II above to UN 3077 and UN 3082 is in accordance with special provision A97 of these Technical Instructions.
Note 3.- The list of Hazardous Substances and the applicable RQ as shown in Appendix A to 49 CFR 172.101 is available via the internet at:
Other materials. Materials which are not subject to the requirements of these Technical Instructions but meet the definition of a hazard class in 49 CFR Parts 171-180 must be transported in accordance with those regulations.
This article or substance may be transported on cargo aircraft only with the prior approval of the appropriate authority of the State of Origin and the State of the Operator under the written conditions established by those authorities.
Where States, other than the State of Origin and the State of the Operator, have notified ICAO that they require prior approval of shipments made under this special provision, approval must also be obtained from the States of transit, overflight and destination, as appropriate.
In each case the conditions must include the quantity limitations and packing requirements and these must comply with S-3;1.2.3 of the Supplement. A copy of the document(s) of approval, showing the quantity limitations and the packing and labelling requirements, must accompany the consignment. Transport in accordance with this special provision must be noted on the dangerous goods transport document.
Sondervorschrift A131
Glass inner receptacles (such as ampoules or capsules) intended only for use in sterilization devices, when containing less than 30 mL of ethylene oxide per inner packaging with not more than 300 mL per outer packaging, may be transported in accordance with the provisions in 3;5, irrespective of the indication of "forbidden" in columns 10 to 13 of Table 3-1, provided that:
a) after filling, each glass inner receptacle has been determined to
be leak-tight by placing the glass inner receptacle in a hot water
bath at a temperature, and for a period of time, sufficient to
ensure that an internal pressure equal to the vapour pressure of ethylene oxide at 55 °C is achieved. Any glass inner receptacle
showing evidence of leakage, distortion or other defect under this
test must not be transported under the terms of this special
provision;
b) in addition to the packaging required by 3;5.2, each glass inner
receptacle is placed in a sealed plastic bag compatible with
ethylene oxide and capable of containing the contents in the event
of breakage or leakage of the glass inner receptacle; and
c) each glass inner receptacle is protected by a means of preventing
puncture of the plastic bag (e.g. sleeves or cushioning) in the
event of damage to the packaging (e.g. by crushing).