UN 1005 Ammonia, anhydrous, liquefied under pressure ADR 2025 (Shortinfo)

Name: Ammonia, anhydrous, liquefied under pressure (Shortinfo, ADR 2025, English)
Creator: Bundesanstalt für Materialforschung und -prüfung (BAM)
Keywords: Dangerous Goods Database Information Transport Regulations Classification Marking Labelling Table A List Of Dangerous Goods

BAM name (German)	Ammoniak, wasserfrei, unter Druck verflüssigt
BAM name (English)	Ammonia, anhydrous, liquefied under pressure
BAM name (French)	Ammoniac, anhydre, liquéfié sous pression
Aggregate state (under normal conditions)	gaseous
BAM no.	98
CAS no.	7664-41-7
Detailinfo

German	AMMONIAK, WASSERFREI
English	AMMONIA, ANHYDROUS
French	AMMONIAC ANHYDRE
Detailinfo

Transport status	allowed
Tunnel restriction code	Tunnel restriction code: C/D Tank carriage: Passage forbidden through tunnels of category C, D and E; Other carriage: Passage forbidden through tunnels of category D and E.
Detailinfo

UN no.	1005
Class
Classification code
Packing group
Special provisions	, Special provision 23 Even though this substance has a flammability hazard, it only exhibits such hazard under extreme fire conditions in confined areas. Special provision 379 Anhydrous ammonia adsorbed or absorbed on a solid contained in ammonia dispensing systems or receptacles intended to form part of such systems are not subject to the other provisions of ADR if the following conditions are observed: (a) The adsorption or absorption presents the following properties: (i) The pressure at a temperature of 20 °C in the receptacle is less than 0.6 bar; (ii) The pressure at a temperature of 35 °C in the receptacle is less than 1 bar; (iii) The pressure at a temperature of 85 °C in the receptacle is less than 12 bar. (b) The adsorbent or absorbent material shall not have dangerous properties listed in classes 1 to 8; (c) The maximum contents of a receptacle shall be 10 kg of ammonia; and (d) Receptacles containing adsorbed or absorbed ammonia shall meet the following conditions: (i) Receptacles shall be made of a material compatible with ammonia as specified in ISO 11114-1:2020; (ii) Receptacles and their means of closure shall be hermetically sealed and able to contain the generated ammonia; (iii) Each receptacle shall be able to withstand the pressure generated at 85 °C with a volumetric expansion no greater than 0.1 %; (iv) Each receptacle shall be fitted with a device that allows for gas evacuation once pressure exceeds 15 bar without violent rupture, explosion or projection; and (v) Each receptacle shall be able to withstand a pressure of 20 bar without leakage when the pressure relief device is deactivated. When carried in an ammonia dispenser, the receptacles shall be connected to the dispenser in such a way that the assembly is guaranteed to have the same strength as a single receptacle. The properties of mechanical strength mentioned in this special provision shall be tested using a prototype of a receptacle and/or dispenser filled to nominal capacity, by increasing the temperature until the specified pressures are reached. The test results shall be documented, shall be traceable and shall be communicated to the relevant authorities upon request.
Detailinfo

Labels

Marks

Orange-coloured plate for tanks

Orange-coloured plate: Hazard identification number 268, UN number 1005

Hazard identification number	268	toxic gas, corrosive
UN number	1005	AMMONIA, ANHYDROUS

Limited quantities	No exemption according to the provisions of Chapter 3.4 possible
Excepted quantities	E0, No exemption according to the provisions of Chapter 3.5 possible
Limited quantity according to 1.1.3.6	50 kg
Transport category	1
Detailinfo

Packages	none
Loading, unloading and handling	, Loading, unloading and handling: CV9 Packages shall not be thrown or subjected to impact. Receptacles shall be so stowed in the vehicle or container that they cannot overturn or fall. , Loading, unloading and handling: CV10 Cylinders as defined in 1.2.1, shall be laid parallel to or at right angles to the longitudinal axis of the vehicle or container; however, those situated near the forward transverse wall shall be laid at right angles to the said axis. Short cylinders of large diameter (about 30 cm and over) may be stowed longitudinally with their valve-protecting devices directed towards the middle of the vehicle or container. Cylinders which are sufficiently stable or are carried in suitable devices effectively preventing them from overturning may be placed upright. Cylinders which are laid flat shall be securely and appropriately wedged, attached or secured so that they cannot shift. Loading, unloading and handling: CV36 Packages shall preferably be loaded in open or ventilated vehicles or open or ventilated containers. If this is not feasible and packages are carried in other closed vehicles or containers, gas exchange between the load compartment and the driver's cab shall be prevented and the cargo doors of the vehicles or containers shall be marked with the following in letters not less than 25 mm high: "WARNING NO VENTILATION OPEN WITH CAUTION" This shall be in a language considered appropriate by the consignor. For UN Nos. 2211 and 3314 this mark is not required when the vehicle or container is already marked according to special provision 965 of the IMDG Code ). __________ ) Warning mark including the words "CAUTION - MAY CONTAIN FLAMMABLE VAPOUR" with lettering not less than 25 mm high, affixed at each access point in a location where it will be easily seen by persons prior to opening or entering the vehicle or container.
Operation	Operation: S14 The provisions of Chapter 8.4 concerning the supervision of vehicles shall apply for vehicles carrying any amount of these substances.
Detailinfo

Instructions	P200
Special provisions	none
Mixed packing	Mixed packing: MP9 May be packed together in an outer packaging for combination packagings in accordance with 6.1.4.21: - with other goods of Class 2; - with goods of other classes, when the mixed packing is also permitted for these; or - with goods which are not subject to the requirements of ADR, provided they do not react dangerously with one another.

Transport in intermediate bulk containers (IBCs) is not permitted.

Transport in large packagings is not permitted.

Portable tanks (UN tanks)

Tank instruction

Special provisions

ADR tanks

Tank code

Special provisions

Vehicle for tank carriage
Tank vehicle	Tank vehicle: AT (a) A vehicle, other than EX/III or FL vehicle or than a MEMU, intended for the carriage of dangerous goods in fixed tanks or demountable tanks with a capacity exceeding 1 m³ or in tank-containers, portable tanks or MEGCs with an individual capacity exceeding 3 m³; or (b) A battery-vehicle with a total capacity exceeding 1 m³ other than a FL vehicle.

Transport in bulk is not permitted.

Transport in bulk containers (BK containers) is not permitted.

Drill letter 1
Drill number
Inherent hazard
Hazard to aircraft
Hazard to occupants
Spill or leak procedure
Firefighting procedure
Additional considerations
Drill letter 2

Navigation/Einstellungen

Seiten

Verkehrsträger/Vorschrift

Sprache

UN 1005 Ammonia, anhydrous, liquefied under pressure ADR 2025 (Shortinfo)

UN 1005 Ammonia, anhydrous, liquefied under pressure ADR 2025 (Shortinfo)

Substance information(collapsed)

Transport document names (collapsed)

Transport exlusions (collapsed)

Classification (collapsed)

Labelling (collapsed)

Limited and excepted quantities (collapsed)

Special provisions for carriage (collapsed)

Containments (collapsed)

Pack­ag­ings (collapsed)

In­ter­me­dia­te bulk con­tai­ners (IBC) (collapsed)

Large pack­ag­ings (collapsed)

Tanks (collapsed)

Bulk (collapsed)

Bulk con­tai­ners (collapsed)